Yellow Terminator is Fully Recovered and Touge Session

Past few weeks, this yellow terminator is sent into workshop to do the front panel where its found cracked and putting the driver who is a touge enthusiasts endanger. The panel change to japanese car where bought from halfcut shop.. panel was cut out and awaiting of replacement.

Above Pictures are the cracked panel taken out and awaiting for replacement.

The car done on Friday and during sunday where no raining, me, alvin and robert having DIY at alvin house.. the workshope did not put any antirust or spray after the panel welding is done so easily get rusty and may causes a lot of problems, so what is the DIY??

Apply Anti Rust and Spray Black for the EVO panel... Yeah.. Here it begins

(Bumper Removed)

(Trying to remove the headlamp, but due to insufficient tools and kund fu, aiya.. just cover with newspaper when spray)

(Rusty Welding part, left and right)

(After Anti-Rust applied and spray)

(This is the Anti-Rust that he apply)

(Fix Back the bumper and its DONE, so this car is ready to touge!!)

(Pirated Ultra Racing Anti Roll Bar - 12mm only)

The Rear Anti Roll Bar is taken out from GTI and ready to be install in the yellow 1.3 chasis.. We finish everything around 7 o'clock and we have dinner together, after dinner the best thing for us is snooker since we got time.. after some discussion, we decided to go touge since it is not raining..

We depart to touge at around 11.45pm, I take the lead for uphill and Robert take the lead for downhill. There is a part of the road under wet condition and we slow down, after that we continue to hamtam again and that was fun!!

We have a rest for 5 - 10 minutes at dam and we continue with the downhill, why izit so fast? Because all of us is working on the next day morning. Will try to get the vid from robert and upload here.